Replacing Vacuum Bag and Filters
Replacing the vacuum bag
Change the vacuum bag when the full bag indicator
light is flashing RED or suction power is weak. The
bag compartment will not close without a bag in the
unit or if the bag is not properly installed.
1. Open the bag compartment.
2. Pull the tab on the cardboard bag collar, closing
the bag while removing it from the bag holder.
3. Remove and discard the used bag. NOTE:
The Performance HEPA™ bag cannot be reused.
4. Slide a new bag into the bag holder until it
clicks into place.
Replacing the secondary filter
1. Open the bag compartment and locate
the filter behind the vacuum bag. For
better access to the secondary filter,
remove the bag.
2. Pull the filter holder out toward you.
3. Remove the used filter and replace it with
a new filter.
4. Slide the filter holder back in place and
replace the bag.
Replacing the HEPA filter
1. Locate the HEPA filter inside the bag
compartment near the door hinge.
2. Lift up the black tab to remove the used filter
and snap in a new filter. NOTE: The HEPA
filter cannot be washed and reused.
To Next Page
Loading...
