Richman RM20-2SS - Install Battery Module; Battery Installation Cautions

ITM. / ART. 966690
RM20-2SS Traveler Grill
5.Install Battery Into Electronic Igniter Module
Unscrew electronic igniter cap, install battery (L) by inserting the negative (-) end first so that the
positive (+) end is facing outward, then screw cap onto electronic igniter, as shown in picture.
10
6. Congratulations – Assembly Is Now Complete
• Do not remove the CSA label and Ignition / Warning instruction labels. Be sure to clean all foam packing
material out of all areas.
• Please proceed to and read the remaining sections of the Operator’s Manual prior to hooking up your LP
cylinder or operating your grill.
L 1pc
CAUTIONS: BATTERY INSTRUCTIONS
• Always purchase the correct size and grade of
battery most suitable for the intended use.
• Always replace the whole set of batteries at one
time, taking care not to mix old and new ones, or
batteries of different types.
• Clean the battery contacts and also those of the
device prior to battery installation.
• Ensure the batteries are installed correctly with
regard to polarity (+ and -).
• Remove batteries from equipment which is not to be
used for an extended period of time.
• Remove used batteries promptly.
For recycling and disposal of batteries to protect the
environment, please check the internet or your local
phone directory for local recycling centers and / or
follow local government regulations.
+
Polarity
-
L
+
08/28/13
9