Richman RM20-2SS - Igniting with a Match; Flame Appearance Guide

To Next Page

To Previous Page

IGNITE / HI

Appearance Of The Flame

• The burner flame should appear blue and stable as shown in pictures. There should be no yellow sparks,

loud noise nor should it be raised up from the nozzle.

• A yellow flame means that there is not enough oxygen supply. Loud noises and a flame raised up from the

nozzle means that there is too much oxygen.

• Check the appearance of the burner flame prior to each use. Should deviations be present, contact a gas

specialist to reset the grill.

ITM. / ART. 966690

RM20-2SS Traveler Grill

Igniting The Gas Grill With A Match

1. Open the lid.

2. Ensure all burners are in the “OFF” position.

3. Slowly turn on the gas at the LP cylinder valve if it is not already on.

4. Place a match in the match light stick. This is located on the side of the grill.

5. Use the stick to slide the lit match through the cooking grates and the front of the heat

diffuser to the burner you wish to light.

6. Press and turn the burner control knob to “IGNITE/HI”. Continue to push in and hold up to 5 seconds

or until the burner lights.

7. If the burner does not light within 5 seconds, turn the burner control knob to “OFF”. Wait 5 minutes

for gas to clear, and try again.

8. When lit, turn the control knob to the desired heat setting.

OFF

08/28/13

1 in.

2.5cm