Ricoh 35 - Setting Shutter Speed and Aperture

FLASH PHOTOGRAPHY
I, MiiMlil I he llarll-gun »ii the im-sstry
shut: and mrmeci die cord u» the FLASI L-
CONNECTCR. When you use the;
RICOH BC-G05D flash unit, you need not
U^e oonnEclinj^ cord since: the Ricoh 35L
is equipped with the direct contact
on the accessory shoe.
2f Set the "MT SYNCHRONIZATION
LEVER at ''X" when you use the
electronic flash unit Eirtd set at “W*
with the flush unit. IM-J.t
3. Correct shutter speed must be selected in
combination of die flash hulh used mid
synch roiiizn lion lever setting as shown by
the lahle. (35)
■ I. Focus die subject and measure the dis¬
tance hy the distance scale, C34)
.5. Read the instructions of die flash bylb
you use and. obtain Lis Guide Number
coiTCHjjojulin^ with the fthan speed miff
the shutter speed you are using,
5. Divide the guide number hy the distance
scale figure. Thus obtained number is
die correct aperture. Set this aperture
on the rainCnL. Advance die film and
relense die shutler.
Id
*
Class F B t 1— 1/150 Unsuitable
Class M
All speeds,
STRUBO
All speeds
Will not synch.
NOTE ; When using self-timer (lever set elL "V"),
SyiidinmiiAlion is same as H 'X" setting.