Mode No. Function Settings
Class 1 Class 2
5902
Duplex Tray
Capacity Limit
for A3 Copies
Selects the total capacity of the duplex
tray for A3 paper.
50 sheets
30 sheets
If there are frequent jams at the duplex
unit when using A3 paper, try setting this
to 30.
5920 *
Fusing Temp.
Setting - Low
Power Mode
Selects the fusing temperature that will be
used in low power mode.
(115V ver.)
125
°°
C
100
°
C
(230V ver.)
170
°
C
155
°°
C
125
°
C
100
°
C
If a low temperature is selected, it takes
more time to reach the ready condition.
✽
5945
Option Bus
Interface
Check
Check the optional bus interface with the
dummy board from the SCU through the
extension board.
Before this test is performed, the main
controller should be replaced with the
dummy board.
See the "OPTIONAL BUS INTERFACE
CHECK" section for details.
✽
5946
Printer
Controller
Disk Error Log
Clear
To clear the error log of the controller
disk. See the "PRINTER CONTROLLER
ERROR LOG" section for details.
5990
1
SP Mode
Data Printing
(All Data)
Prints all the system parameter lists.
See the "SYSTEM PARAMETER AND
DATA LISTS" section for how to print the
lists.
Printing takes 6 minutes.
2
SP Mode
Data Printing
(SP Mode
Data)
Prints the SP mode data list.
See the "SYSTEM PARAMETER AND
DATA LISTS" section for how to print the
lists.
Printing takes 2 minutes.
3
SP Mode
Data Printing
(UP Mode
Data)
Prints the UP mode data list.
See the "SYSTEM PARAMETER AND
DATA LISTS" section for how to print the
lists.
Printing takes 2 minutes.
4
SP Mode
Data Printing
(Machine
Status Data)
Prints the machine status history data list.
See the "SYSTEM PARAMETER AND
DATA LISTS" section for how to print the
lists.
Printing takes 2 minutes.
SERVICE PROGRAM MODE TABLES 25 April 1997
30
To Next Page
Loading...
