Taurus-C1 Training
5
Slide 5
Printer Model – Basic System
(1): Main Unit 1st Tray (1000 sheets x 2)
(2): Main Unit 2nd Tray (500 sheets)
(3): Optional A3/DLT LCIT 1st Tray (1000 sheets)
(4): Optional A3/DLT LCIT 2nd Tray (2000 sheets)
(5): Optional A3/DLT LCIT 3rd Tray (1000 sheets)
(6): Optional Bypass Tray (500 sheets)
(7): Optional Finisher (two different ones are available)
This shows the printer model with minimal optional peripherals attached. The
only obvious difference from the copier is that there is no ARDF.
The following are the same as for the copier model:
¾ Only one LCIT can be installed.
¾ There is no A4/LT LCIT option.
¾ Two finisher models are available: The D512 (corner stapling and booklet
stapling), and the D513 (corner stapling only).
The finisher (7) in the illustration above is the Booklet Finisher D512 .
To Next Page
Loading...
Need help?
General
