103
MO-C1 Training
Slide 103
Moving the Machine - 1
When moving the machine to another location in the same
room or the same building:
Two people are required to move the machine to a new
location.
To prevent ink spillage, never lift or tip the machine from the
level position.
Make sure that the four screws that connect the scanner
stand to the main unit stand are attached and securely
fastened.
» Never attempt to move the machine with the scanner stand
detached from the main unit.
The scanner stand and scanner unit assembly is extremely
top heavy and can tip over easily.
Make sure that the four casters of the main unit stand and
scanner stand are unlocked.
It is not necessary to remove the ink cartridges.
Position your hands at base of the main unit and then push
it slowly to the new location.
Before ink is installed, the machine can be tilted by 70 degrees, such as when
carrying the machine up stairs. However, after the machine has been used, the
machine should not be tilted by more than 45 degrees, or ink could come out
from the ink sump.
To Next Page
Loading...
