Ricoh GR Digital II - Macro shooting at 1.5 cm and close-up flash shooting at 20 cm; Up-down dial and ADJ. lever for efficient operations; Customizing settings with my settings mode

5
4. Update the firmware
1.
Making sure that the camera’s power is
turned off, switch the mode dial to SCENE.
2. While pressing the MODE button, hold
down the 6 (Playback) button for 2-3
seconds.
• A confirmation message for the firmware update is
displayed on the picture display.
3. Press the $ button to select [Yes], and
press the MENU/OK button.
• The firmware update starts, and the following message is displayed on the picture display.
[Checking rewrite file]
[Rewriting program]
4. The camera automatically turns off and restarts.
• If the message [Incorrect rewriting file] is displayed and the camera is automatically turned off, check the camera model
again and retry the update using the correct firmware.
• The firmware file copied to the SD memory card is deleted when you format the SD memory card. Delete the file if
necessary.
6 (Playback) Button
MODE
Button
Mode dial
MENU/OK Button