Ricoh GR III - Page 9

9
◆Shooting Function
Q: Please tell me about [Image Control] function.
・For GR III (firmware version 1.20 or earlier)
To update to the latest GR III firmware version, click here.
A: By changing the saturation, color or contrast you can create characteristic images.
Standard
Normal image
Vivid
Create sharp and colorful image.
Monotone
Black & White
Soft Monotone
Create soft impression of B&W image
Hard Monotone
Create solid impression of B&W image
Hi-Contrast B&W
Create B&W image that emphasize contrast. It will show up grained image
such as used ultra-fast film or result of the sensitized development.
Positive Film
Create high saturation image such as used Positive Film.
Bleach Bypass
Create image that lower saturation and higher contrast.
Retro
Create image like old photograph.
HDR Tone
Emphasize fine contrast and create with image of a painting impression.
Custom1
Custom2
Can be registered 2 kinds of settings
・ (movie) mode: [Soft Monotone] and [HDR Tone] are not usable.
・The [Image Control] is not reflected for RAW image. It can be set when run the [RAW Development]
at the
□
,2 [Image Edit] menu.
・You can set it to [ADJ Mode Setting] and [Fn Button Setting] at C
□
,2 [Customize Controls] menu.
・For GR IIIx
* For the GR III, the same functions as below are available with firmware version 1.30 or later
(click here
).