1. Carefully pull out the paper tray until it stops.
2. Press the metal plate down until it clicks.
3. Square the paper and load it print side up.
Do not stack paper over the limit mark.
4. Carefully push the paper tray fully in.
• When loading a low number of sheets, be sure not to squeeze the side fences in too tightly. If the
paper bows, it might not feed in properly.
• If a paper tray is pushed vigorously when putting it back into place, the position of the tray's side
fences may slip out of place.
3. Adding Paper
72
To Next Page
Loading...
