1. Carefully pull out the paper tray until it stops.
2. Square the paper and load it print side up.
Do not stack paper over the limit mark.
3. Carefully push the paper tray fully in.
• When loading a low number of sheets, be sure not to squeeze the side fences in too tightly. If the
paper bows, it might not feed in properly.
• If a paper tray is pushed vigorously when putting it back into place, the position of the tray's side
fences may slip out of place.
• Various sizes of paper can be loaded in the paper trays by adjusting the positions of side fences and
end fence. For details, see “Changing the Paper Size”.
• Each tray can hold up to 500 sheets.
• p.78 "Changing the Paper Size"
Loading Paper
75
To Next Page
Loading...
Need help?
General
