5
4. Update the firmware
1.
Making sure that the camera’s power is
turned off, switch the mode dial to SCENE.
2. While pressing the ADJ./OK button !,
hold down the 6 (Playback) button for 2-
3 seconds.
• A confirmation message for the firmware update is
displayed on the picture display.
3. Press the ADJ./OK button $ to select
[Yes], and press the ADJ./OK button.
• The firmware update starts, and the following
message is displayed on the picture display.
[Checking rewrite file]
[Rewriting program]
The update is completed in about 40 seconds.
• The camera's power turns off automatically.
4. The camera automatically turns off and restarts.
• If the message [Incorrect rewriting file] is displayed and the camera is automatically turned off, check the camera model
again and retry the update using the correct firmware.
• The firmware file copied to the SD memory card is deleted when you format the SD memory card. Delete the file if
necessary.
ADJ./OK Button
6 (Playback) Button Mode dial
To Previous Page
Loading...
