To Next PageTo Next PageWhat causes tear-out on the milled surface of my Ricon 20-600H Cutter?
Tear-out (also called 'chip out') on the milled surface of your Ricon Cutter can be caused by: * Cutting against the grain. Cut with the grain. For figured woods, take shallow cuts to minimize tear out. * A cut that is too deep. Reduce cutting depth to 1/16" or less. * Dull knives. Rotate insert knives to new sharp edges.
Why is jointed stock concave on the back end of the board when using my Ricon 20-600H Cutter?
If jointed stock is concave on the back end of the board when using your Ricon Cutter, it's likely because: * The knives are set higher than the outfeed table. Raise the outfeed table level with the cutter- head & knives.
Explains symbols like DANGER, WARNING, CAUTION, and NOTICE used in the manual.
Outlines fundamental safety rules for operating power tools and the jointer.
Details crucial safety measures related to the tool's electrical connections and grounding.
Provides guidelines for selecting and using appropriate extension cords safely.
Lists safety precautions specific to the operation and use of jointers.
Lists the items included in the jointer's package and unpacking instructions.
Covers safe methods for moving and securely installing the jointer.
Lists the tools needed for the minimal assembly of the jointer.
Step-by-step guide for assembling the jointer's fence.
Instructions for installing the cutterhead guard for safety.
Details on attaching the dust port for dust collection.
Procedure for attaching the infeed table adjustment knob.
Explains the operation of the on/off switch and lockout feature.
Instructions on how to safely start and stop the jointer.
Guidance on feeding wood with the grain for optimal results.
Basic principles and functions of the jointer for planing wood.
Describes the correct technique for feeding workpieces through the jointer.
How to adjust the jointer to achieve the desired depth of cut.
Procedures for moving and tilting the jointer fence.
Steps to set and adjust the fence to specific angles.
Guide on how to rotate or replace the cutterhead knife inserts.
Instructions for aligning and adjusting the infeed and outfeed tables.
Steps for removing and installing the jointer's drive belt.
Illustrates the electrical connections of the jointer.
General