To Next PageTo Next Page
Need help?Do you have a question about the Riden RD60 Series and is the answer not in the manual?
Ensure correct interface settings (USB) and boot mode before flashing.
Steps to use RDFlasher on Windows, including firmware file location.
Guide for using the command-line flashtool with Python.
Identifies and describes buttons (POWER, SHIFT, MEM, I-SET, V-SET), ports, and display areas.
Details settings related to battery charging, including cutoff parameters and buzzer.
Covers power, display, communication, units, and date/time settings.
Lists interface, appearance, buzzer, layout, and colors settings.
Accessing and viewing saved memory location values.
Currently not in use, status indicated as "Under Construction".
Displays read-only device information like model, serial, and firmware.
Lists shortcuts and actions applicable only when in graph display mode.
Details how to use the graph in view mode, including indexing and value display.
Instructions for adjusting calibration using Riden software or factory reset.
Instructions on how to open the unit and access internal PCBs.
Details on adding a red LED for multi-color button feedback.
Instructions for adding a front panel power switch to control the PSU.
Tips for enhancing temperature readings using thermal paste.
Information on using the TTL interface for communication.
Details the resistor value change (R22) to fix the output surge.
Guide for first-time WiFi setup using Smart Config.
Steps for running the device when WiFi is already set up.
Procedure for modifying the IP address of the WiFi server.
How to reset and reconfigure WiFi if it fails or needs changes.
Capturing and saving RD60xx display screens to a computer.
Instructions for changing the device's boot logo.
Identifies common battery types and their charging considerations.
Proper procedure for connecting batteries, including terminal usage.
Details on setting V-SET and I-SET for battery charging.
Using time as a limit for battery charging cycles.
Charging based on the total Amp-hour capacity delivered.
Interrupting charge if current drops below a set threshold.
Using temperature as a safety measure during charging.
Charging technique for NiMH/NiCd batteries based on voltage changes.
Maintaining charge on batteries like Lead Acid or Lithium-ion.
Provides access to the official Riden manual.
Information on the types and ratings of fuses used in the units.
Evaluation of the unit's response to short circuit conditions.
Covers fan indicator and minimum battery voltage.
General| Voltage Resolution | 0.01V |
|---|---|
| Capacity Measurement | Yes |
| Energy Measurement | Yes |
| Output Voltage | 0-60V (RD6006/RD6006W), 0-60V (RD6012/RD6012W), 0-60V (RD6018/RD6018W) |
| Display | LCD |
| Operating Temperature | -10°C to +60°C |
| Communication | USB |
| Protections | Over Voltage, Over Current, Over Temperature |
| Cooling | Fan |
