What to do if FlexShaft Machine wobbles or moves while cleaning drain with RIDGID Cleaning Equipment?
If the FlexShaft Machine wobbles or moves while you're cleaning a drain with your RIDGID Cleaning Equipment, make sure you are operating it in a clear, level, and stable location.
Why does my RIDGID Other FlexShaft machine wobble or move when cleaning a drain?
The FlexShaft machine might wobble or move due to several reasons. Make sure the cable assembly is not being forced. Use the correct FlexShaft Machine or chain knocker for the pipe diameter. Ensure the drill is not being run in reverse unless the flex shaft is caught. Also, a corroded cable assembly, a worn-out cable/sheath, or improper support can cause this issue. Finally, be sure that the chain knocker is properly set up and the drill and settings are appropriate. Placing the machine on a level surface is also important.
What to do if motor does not turn on with switch on RIDGID Cleaning Equipment?
If the motor on your RIDGID Cleaning Equipment doesn't turn on with the switch, there could be a few reasons. It might be due to a faulty REV/O-OFF/FOR switch, in which case you should have the switch replaced. Alternatively, the power cord could be damaged, requiring a cord replacement. In the worst-case scenario, there could be a short circuit in the motor, which means you should take it in for service.
Why is the cable kinking or breaking on my RIDGID Cleaning Equipment?
Cable kinking or breaking in your RIDGID Cleaning Equipment can occur if the cable assembly is being forced. To prevent this, avoid forcing the cable assembly and follow the operating instructions.
What to do if cable assembly exposed to acid or corroded on RIDGID Cleaning Equipment?
If the cable assembly of your RIDGID Cleaning Equipment is exposed to acid or corroded, it's likely that the cable or sheath is worn out. In this case, you should replace the worn cable assembly.
Why does the cable turn in one direction but not the other on RIDGID Cleaning Equipment?
If the cable on your RIDGID Cleaning Equipment turns in one direction but not the other, it could be due to using an incorrect FlexShaft Machine or chain knocker for the pipe diameter. Ensure you are using the correct FlexShaft Machine or chain knocker for the pipe size.
How to prevent cable kinking or breaking in my RIDGID FlexShaft K9-204 FlexShaft machine?
To prevent cable kinking or breaking, avoid forcing the cable assembly. Ensure you're using the correct FlexShaft Machine or chain knocker for the pipe size. Use reverse only if the flex shaft gets caught. Routinely clean the cable assembly to avoid corrosion. Replace the cable assembly if it's worn out and support it properly according to the instructions. Also, properly set up/adjust the chain knocker as per the instructions and choose the proper drill and settings.
To Next Page
General