Required Maintenance By
RIDGID Independent Service
Center
The PEX-One Crimp Tool must be serviced at
set intervals by a RIDGID Independent Service
Center to ensure proper operation. This will
be indicated by the Tool Work/Status light (See
Figure 6).
Service and Repair
WARNING
Improper service or repair can make the
machine unsafe to operate.
Service and repair on the PEX-One Crimp
Tool must be performed by a RIDGID Inde -
pendent Service Center. Use only RIDGID
service parts.
Optional Equipment
WARNING
To reduce the risk of injury, only use e -
quipment specifically designed and rec-
ommended for use with the RIDGID PEX-
One Crimp Tool, such as listed below.
PEX-One Crimp Tool
085-003-980.10_REV. A
10
Disposal
Parts of this tool contain valuable
materials and can be recycled. There are
companies
that specialize in recycling that
may be found locally. Dispose of the
components in compli-ance with all
applicable regulations. Contact your local
waste management authority for more
information.
For EC Countries: Do not dispose
of elec trical equipment with house-
hold waste!
According to the European Guide -
line 2012/ 19/EU for Waste Elec trical
and Electronic Equipment and its
imple men tation into national legislation, elec-
trical equipment that is no longer usable must
be collected separately and disposed of in
an environmentally correct manner.
EC Declaration of
Conformity
The EC Declaration of Conformity (890-011-
320.10) will accompany this manual as a sep-
arate booklet when required
Electromagnetic
Compatibility (EMC)
The term electromagnetic compatibility is
taken to mean the capability of the product to
function smoothly in an environment where
electromagnetic radiation and electrostatic
discharges are present and without causing
electromagnetic interference to other equip-
ment.
This tool conforms to all applicable
EMC standards. However, the possibility of
it causing interference in other devices cannot
be precluded. All EMC related standards that
have been tested are called out in the tool’s
technical document.
Catalog
No. Description
54253 PEX-One Tool Kit (ASTM)
56638 PEX-One Tool Only
56568 ASTM Die Kit (
1
/
2
",
3
/
4
", 1")
56573 ASTM Die Set
1
/
2
"
56578 ASTM Die Set
3
/
4
"
56583 ASTM Die Set 1"
56608 Bag, 20", Soft-Sided
56603 Die Caddy
29583 Go-No Go Gauges (ASTM)
All listed batteries will work with any catalog number RBC-121
Battery Charger.
NOTICE
Catalog
Capacity
No. Region
55183 12V 2.5Ah All
Battery Packs
Catalog Plug
No. Region Type
55193 Charger USA, Canada and Mexico A
44798 Charger Cord North America A
RBC-121 Chargers and Cords
To Next Page
Loading...