C6505020 STD G400 Manual Rev.5 -06/10/2002 1
40 SERIES GAS BURNER
MODEL 400 NATURAL GAS/PROPANE
INSTALLATION INSTRUCTIONS AND OWNER’S HANDBOOK
CAUTION: All gas burners MUST be installed by trained and licensed technicians.
WARNING: Installation of this burner must conform with local codes or, in the absence of local codes, with
the Standard for the Installation of Domestic Gas Conversion Burners, ANSI Z21.8-1984, and Addendum,
Z21.8a-1989, and the National Fuel Gas code, ANSI Z223.1-1984, and CAN/CGA B149.1 &.2. If an external
electrical source is utilized, the conversion burner, when installed, must be electrically grounded in
accordance with local codes or, in the absence of local codes, with the national Electrical Code, ANSI/NFPA
No. 70-1990 and CSA Electrical Code.
Owner is required to retain this manual for future reference.
TECHNICAL SPECIFICATIONS
FIRING RATE 170,000 TO 400,000 Btu/hr
NATURAL PROPANE
GAS SUPPLY PRESSURES
MANIFOLD PRESSURES
MIN. 4" w.c.
MAX. 10" w.c.
MIN. 0.90" w.c.
MAX. 1.80" w.c.
MIN. 8" w.c.
MAX. 13" w.c.
MIN. 1.04" w.c.
MAX. 3.04" w.c.
POWER 120 VOLTS 60 Hz 1 PHASE
MOTOR 232T 2.2 AMPS 3250 RPM
CONTROL MODULE 525 SE/A ELECTRONIC
WARNING: If the information in these instructions is not followed exactly, a fire or
explosion may result causing property damage, personal injury or death.
Do not store or use gasoline or any other flammable vapours or liquid in the
vicinity of this or any other appliance.
WHAT TO DO IF YOU SMELL GAS:
1) Do not try to light any appliance.
2) Do not touch electrical switches; Do not use any phone in your building.
3) Immediately call your gas supplier from a neighbour's phone. Follow the gas
supplier's instructions.
4) If you cannot reach your gas supplier, call the fire department.
Installation and service must be performed by a qualified installer, service agency
or the gas supplier.
To Next Page
Need help?
General
