After you are satisfied with your program simulation and
have downloaded it to xLogic CPU, you can also perform
an online test of the circuit program. An online test is
similar to simulation in that you can view inputs and
outputs and block parameters. It differs, however, in that
you are testing the program running in the xLogic with
"live" inputs rather than testing the program on the PC
with simulated inputs.
Multiple registers can be accessed individually by clicking
“Tools->Set Monitor Config”.
Monitor mode:
Under monitor mode, the user can change the state of the
spare outputs Q002 and Q003 because the input pin of
the block is not connected to any other blocks. This is
achieved by Right clicking your mouse on the input side
of the block and selecting Set Output State from the pop-
up window.
Right click "Q2" and then click "Set Output State".
Click "OK" button and the Q2 of xLogic will be turned off.
How to Transfer Monitoring data (AI/AQ) to an Excel
file?
Example program:
1. Select Tools-> Set Monit Config.
To Next Page
Loading...
