The menu File->Properties (Parameter)
There are 2 password settings which can be applied to
the program, one is the program password and the
other is the parameter password.
Program password:
If you set the program password, then the password is
required when you want to upload the program to PC.
Parameter password:
If you set the parameter password, then the
password is required when you want to
change parameters via the LCD.
NOTICE:
1.The password which can be set in the LCD
menu is the parameter password.
2.The program password cannot be set in the
LCD menu, it can only be set in xLogicsoft.
5.4.5. How to Set the Address of a CPU and
Expansion Modules
Setting the CPU Address
If there is more than one CPU in a communication network,
then the address of each CPU must be different. You can
change the address of CPU via xLogicsoft or via the panel
key if the CPU with LCD panel. The address range is from
1 to 247 for ELC and PR series CPUs.
Confirm with "OK"
Change the address with arrow keys and
confirm with "OK".
The CPU address can also be set by xLogicsoft if the CPU
is without HMI.
To Next Page
Loading...
