2. Message Configuration
a. Incoming Message – If this option is
selected, then the input state can be
switched using a SMS message, which
MUST match the On and Off
instructions configured in this section.
Default values are “1#1” for ON and
“1#0” for OFF.
b. Number Identification – If this box is
ticked, then only SMS received from
those configure in the Telephone
section will be acted upon.
c. On Instruction – Define the text that
will switch this input TRUE. Default is
1#1.
d. OFF Instruction – Define the text that
will switch this input FALSE. Default is
1#0.
e. Off-Delay – If this box is ticked and a
time in seconds configured, then once
a SMS “On” message is received and
accepted, the input will switch to TRUE
and reset to FALSE once the time has
expired.
3. Incoming Call Configuration
a. By ticking the box for this feature, then
the input will become TRUE when a
call is received. Once the call is
stopped or Off-Delay timer expires,
the input will revert to its FALSE state.
b. Answer Call – If this is selected, then
the CPU will answer the call made to
it and sets the input to TRUE for 10-
seconds or until you hang up if sooner.
This is a good way to check the CPU
recognises your number. If this option
is not selected, because the CPU
would not answer your call, then no
charge should result on your phone
bill.
4. Telephone Receiver Configuration
In this section you can choose up to a maximum of five
contacts from the phonebook for which this block will
accept instructions for changing state.
To Next Page
Loading...
