RIGOL
2-58 © Copyright RIGOL Technologies, Inc. 2007.
User Manual for DM3000 Series
If there is no need to store at the moment or store it later. Press Apply to scan and
measure.
Figure 2－75
Press Run, start up the current scanning task and begin to measure.
Figure 2－76
The instrument will measure the set of scanning tasks one by one after it is running.
Operation hint：
1． The system will exit the scanning function after the measure is over and
return the function interface before.
2． Press while the scanning task is running for a few times, the current
task will stop.
2．To edit the scanning task
Press Edit, enter the task editing interface.
Figure 2－77
To Next Page
Loading...
