RIGOL
© Copyright RIGOL Technologies, Inc. 2007. 1-29
User Manual for DM3000 Series
To Measure Arbitrary Sensor
To set an arbitrary sensor, you will need to set the sensor name, sensor type, sensor
physical unit, sensor reference data, and arithmetic.
Figure 1-37
Table 1-11 Period Test characteristics
New Newly built sensor reference data file
Edit Edit a sensor reference data file
Load Load a sensor reference data file
Display Set display mode
Basic measurement:
1. Connect test leads as Figure 1-48, 1-49 shown. Red test leads connect the HI
Terminal, Black test leads connect the LO Terminal.
2. Press to select the Sensor function.
3. Press New ,enter the newly- built sensor reference data file interface.
Figure 1-38
(1). In New function interface, you are allowed to edit the sensor Name, sensor Type
and physical value Unit of the sensor.
Figure 1-39
To Next Page
Loading...
