RIGOL
© Copyright RIGOL Technologies, Inc. 2007. 2-23
User Manual for DM3000 Series
Single Triggering
The multimeter takes one reading, or a number of readings specified by a sample
count you enter, each time you press.
Press Æ Single , enter the menu shown below:
Figure 2-21
Table 2-17 Single Trigger Function Menu Explanation
Function
Menu
Explanation
Single Set a sample count, the default sample count is 1.
Save all changes, back to a higher level menu.
Sample Count
While the multimeter receives a single trigger single, the multimeter takes one
reading or a number of readings.
The number of sample count scope from 1 to 50,000. The factory default is 1.
To Next Page
Loading...
