RIGOL
2-42 © Copyright RIGOL Technologies, Inc. 2007.
User Manual for DM3000 Series
Set Up GPIB I/O Parameter
Each device on the GPIB (IEEE–488) interface must have a unique address. You can
set the multimeter’s address to any integral value between 0 and 30. The address is
set to “01” when the instrument is shipped from the factory.
Press Æ I/O Æ GPIB , enter the menu shown below:
Figure 2-49
Table 2-29 GPIB I/O Setting Function Menu Explanation
Function Menu Explanation
Default Use default value.
Save all changes, back to a higher level menu.
To Next Page
Loading...
