Rigol DS1102Z-E User Manual

Chapter 14 Remote Control RIGOL
DS1000Z-E User Guide 14-1
Chapter 14 Remote Control
DS1000Z-E oscilloscope can be controlled remotely mainly through the following two
methods.
User-defined programming
Users can program and control the oscilloscope by using the SCPI (Standard
Commands for Programmable Instruments) commands. For more information about
the commands and programming, refer to the DS1000Z-E Programming Guide .
Use PC software
Users can use PC software to send commands to control the oscilloscope remotely.
Ultra Sigma of RIGOL is recommended. You can download Ultra Sigma from RIGOL
official website (www.rigol.com).
This oscilloscope can communicate with PC through USB or LAN instrument bus. This
chapter gives a detailed introduction of how to use Ultra Sigma to control the
oscilloscope remotely through various interfaces.
The contents of this chapter:
 Remote Control via USB
 Remote Control via LAN

Rigol DS1102Z-E Specifications

General

Bandwidth	100 MHz
Sample Rate	1 GSa/s
Channels	2
Memory Depth	24 Mpts
Waveform Capture Rate	30, 000 wfms/s
Vertical Resolution	8 bits
Vertical Sensitivity	1 mV/div to 10 V/div
Timebase Range	5 ns/div to 50 s/div
Display	7 inch TFT LCD (800x480)
Trigger Types	Edge, Pulse, Video, Slope
Interfaces	USB Host, USB Device, LAN
Input Impedance	1 MΩ ±2%, 15 pF ±3 pF
Power Supply	100-240 VAC, 45-440 Hz