―
SMA(F)-SMA(F) Adaptor (1pcs)
― SMA(M)-SMA(M) Adaptor (1pcs)
― BNC T Type Adaptor (1pcs)
― 50Ω SMA Load (1pcs)
― 50Ω BNC Impedance Adaptor
connectors. These adaptors are
usually used in common tests and
calibration measurements.
The RF CATV kit includes:
50 Ω to 75 Ω Adaptor (2pcs)
RF CATV Kit
This adaptor is widely used in
measurement devices that need to
switch between different
impedances. It is also used in other
fields, such as broadcasting and TV.
The RF attenuator kit includes:
― 6 dB Attenuator (1pcs)
― 10 dB Attenuator (2pcs)
RF Attenuator Kit
This kit uses coaxial fixed
attenuators and is applicable to
applications that require power level
adjustment or circuit matching.
30 dB High-power Attenuator, 100
W Maximum Power
ATT03301H
This attenuator can be used to
measure high-power signals and
perform terminal matching. For
example, measure and adjust the
power amplifier; match the power
splitter and coupler terminals.
N (M)-N (M) RF Cable
CB-NM-NM-75-L-
12G
Coaxial RF cables are usually used
in radio communication system and
electronic devices. Its frequency can
be up to 12.4 GHz and the insertion
loss at 6 GHz is lower than 0.9 dB.
N (M)-SMA (M) RF Cable
CB-NM-SMAM-75
-L-12G
7. Add RF Demo Kit
RF Demo Kit (Transmitter)
TX1000
modularized circuit design and
mainly consist of the mixer, filter
and amplifier. They provide
independent measurement
interface for each part and allow
users to exchange all the parts. You
can use them to learn the principle
and performance of the part and
module as well as use them to learn
how to debug the system. They are
widely used in teaching (such as
communication principle and
high-frequency electronics).
RF Demo Kit (Receiver)
RX1000
To Next Page
Loading...
Need help?
General
