Need help?Do you have a question about the Rigol DS1102Z-E and is the answer not in the manual?
General| Bandwidth | 100 MHz |
|---|---|
| Sample Rate | 1 GSa/s |
| Channels | 2 |
| Memory Depth | 24 Mpts |
| Waveform Capture Rate | 30, 000 wfms/s |
| Vertical Resolution | 8 bits |
| Vertical Sensitivity | 1 mV/div to 10 V/div |
| Timebase Range | 5 ns/div to 50 s/div |
| Display | 7 inch TFT LCD (800x480) |
| Trigger Types | Edge, Pulse, Video, Slope |
| Interfaces | USB Host, USB Device, LAN |
| Input Impedance | 1 MΩ ±2%, 15 pF ±3 pF |
| Power Supply | 100-240 VAC, 45-440 Hz |
Provides essential safety precautions for operating the instrument to prevent injury and damage.
Explains hazard warnings, cautions, and safety symbols used in the manual and on the product.
Details how to select the signal source (CH1, CH2, EXT, AC Line) for triggering the oscilloscope.
Introduces the various trigger types available for capturing specific waveform events, including Edge, Pulse, and Serial Bus triggers.
Lists common operational problems and provides step-by-step solutions for troubleshooting.
To Next Page
