Count UP
1. Press the MODE button to select the TIMER mode, The timer 00:00 with a small icon TIMER will
be shown in the upper part of the display. If the timer setting is not 00:00, press the CLEAR to clear
the setting to 00:00.
2. Press the ST/SP button to start count up. The TIMER will blink indicating count up timer is
running. The maximum count up that can be reached is 99 hours and 59 minutes.
3. To stop the count up process, press the ST/SP button. The TIMER becomes solid.
4. Press the CLEAR to clear the setting back to 00:00.
5. When count up timer reaches 59 minutes and 59 seconds. it will automatically change to Hour:
Minute display format.
Helpful Hints
1.
wait for probe to reach room temperature. If LLL or HHH is still displayed or you get a false
temperature, squeeze the probe jacks harder into the transmitter and twist them back and
forth so they make good contact. If the problem still persists, it is likely the internal probe
wire has shorted out either through moisture or heat damage.
2. Do not immerse the probe in water wile cleaning.
3. Do not allow the probe or probe wire to come into contact with flames.
4. If the temperature displayed seems to read too high or the temperature seems to increase
too quickly, check to make sure the probe tip is not poking through the food. Reposition the
probe tip in the center of the thickest part of food. Avoid touching bone or heavy fat areas.
If the receiver and/or the transmitter display LLL or HHH instead of the probe temperature,
Cautions
during or just after cooking. Do not touch with bare hands.
2. Keep the stainless steel probe sensors and wires away from children.
3. Clean the stainless steel probes and dry thoroughly after each and every use.
4. Do not use the unit in the rain. it is NOT rain proof.
5. Do not expose the plugs of the stainless steel probes or the plug in holes of the transmitter
to water or any liquid. This will result a bad connections and faulty readings.
6. Do not expose the receiver or transmitter to direct heat.
7. Do not use stainless steel probes in a microwave oven.
8. The Probe Thermometer registers temperature as low as 32°F and as high as 572°F(300°C).
LLL will be displayed below 32°F and HHH will be displayed above 572°F.Do not use the
stainless probe sensor above 572°F. Doing so will deteriorate the wire.
9. Not intended for use by persons aged 12 and under.
1. Always wear a heat resistant glove to touch the stainless steel probe sensors or wires
To Next Page
Loading...