RIKA Pico - Cleaning and Tipping During Operation; EASY 40 - Operation; EASY 40 - Switch off; Stopping During Ignit or Startphase

|15
EN
14
key display description
EASY OFF
IGNIT
START
EASY 35
Pressing starts the unit.
This is shown by IGNITE in the display; this is
replaced by START after a brief time.
EASY xx appears in the display after the
start phase (xx stands for a value between
30% and 100%, depending on output)
to change the power setting
press „+“ or „-“ keay (the setting will be changed in 5% steps
single press
EASY
EASY
O FF
IGNIT
START
50
Stopping during ignit or startphase
If switching off occurs again 50 sec. within switching on ( -key) (at least 2
sec. -key), the pellet stove returns to inactive status.
If switching off occurs during the ignition process (IGNIT or START) (at least 2
sec. -key), IGNIT OFF or START OFF appears in the display and the burn-out
phase is initiated. The pellet support stops - the flue gas fan continues to burn
any pellet residues (approximately 10 minutes). The stove changes to EASY
OFF.
EASY 40 – operation
key display description
EASY 40
Standard display for stove switched on in
simple heating mode. (40 is the output in %)
EASY 45 Pressing increases output by 5%
EASY 40 Pressing decreases output by 5%
Cleaning and tipping during operation
The automatic cleaning process is conducted every hour for approx. 2 minutes.
During this phase the air vents that are necessary for combustion are blown
clean.
Great cleaning phase (only stoves with automatic turning grid):
The pellet stove enters the burnout phase every 7 hours. A tipping process is
conducted automatically. The start-up phase is automatically re-initiated after
completion of the burnout phase and operation continues
EASY 40 – switch off
key display description
STOP
EASY OFF
The burnout phase is initiated by pressing for
at least 2 seconds (until the change is visible
on the display). The pellet support stops -
the flue gas fan continues to burn any pellet
residues (approximately 10 minutes).
The stove changes to EASY OFF.
change power setting by
pressing the „+“ or „-“ key
(change in 5 % increments)
single press
pressing the button
(until the change is visible
on the display)
EASY
EASY
O FF
IGNIT
START
50