To Next PageTo Next PageWhy is the jointed stock concave after using Rikon Power Tools 20-800H?
If jointed stock is concave on the front end or in the middle of the board after using your Rikon Power Tools Power Tool, it could be: * **Outfeed table height:** The outfeed table may be set higher than the knives. Lower the outfeed table level with the cutter- head & knives. * **Table unlevel:** The table might be out of level. Raise the table ends.
General| Model | 20-800H |
|---|---|
| Voltage | 120V |
| Blade Speed | 3000 FPM |
| Motor | 1/2 HP |
| Chisel Capacity | 1/4 to 1 inch |
Details on motor, cutterhead diameter, speed, and inserts.
Max depth/width, min stock sizes, table and fence dimensions.
Dust port, noise level, overall size, and net weight.
Explanation of symbols and overall safety advice.
Essential steps and checks before using the machine.
Importance of guards, tool removal, and preventing accidental starts.
Rules on machine use, balance, user condition, and securing work.
Dust protection, extension cord use, and additional safety resources.
Critical guidelines for safe electrical connections.
Recommendations and warnings for extension cords.
Detailed safety rules specific to jointer operation.
Information on California's chemical exposure warnings.
Labels and identification of major jointer components.
List of items included and procedures for unpacking.
Safe methods for moving and positioning the jointer.
List of tools needed for assembly.
Step-by-step guide for assembling the fence.
Instructions for installing the cutterhead guard.
Attaching the dust port and table adjustment knob.
Explanation of the power switch and lockout feature.
Procedures for turning the jointer on and off.
Guidance on feeding wood with the grain for best results.
General function and steps for using the jointer.
How to properly feed material through the jointer.
How to adjust the depth of cut setting.
How to adjust the fence position and tilt.
Adjusting fence to specific angles with positive stops.
Procedure for rotating or replacing cutterhead knife inserts.
How to align and adjust the infeed and outfeed tables.
Adjusting the table extension supports for proper alignment.
Steps for replacing the drive belt.
Pre-operation checks, cleaning, and maintenance.
Inspecting knives, lubricating bearings, and table maintenance.
Checking belt tension and electrical schematic.
Visual representation of all jointer components with numbers.
Detailed list of parts with key numbers and part numbers.
Terms and conditions of the product's warranty.
Guide to diagnosing and fixing common problems.
