To Next PageTo Next PageWhy does the red LED light up due to OVERLOAD on my RINCO ULTRASONICS AG Welding System?
If the red LED lights up on your RINCO ULTRASONICS AG Welding System due to an overload, it could be due to several reasons. The maximum welding pressure might be too high, or the generator output may be insufficient for the application. Another potential cause is a fault within the vibration system.
How to troubleshoot a RINCO ULTRASONICS AG Welding System when the generator cannot be switched on?
If your RINCO ULTRASONICS AG Welding System generator won't switch on, check the following: * Ensure the mains plug is properly inserted. * Make sure the EMERGENCY STOP button is released. * Test fuses F1-F5. * Verify the module is correctly inserted and bolted together.
General| Brand | RINCO ULTRASONICS AG |
|---|---|
| Model | HW35-3 |
| Category | Welding System |
| Language | English |
General safety information and device conformity to engineering standards.
Specifies the device's exclusive use for ultrasonic welding of suitable plastics.
Important notes and warnings for safe operation and maintenance.
Guidelines for qualified personnel performing electrical installations.
Instructions for safely installing the device and connecting peripherals.
Guidelines and warnings for safe operation of the device.
General information on the hand held cutting device and ultrasonic generator.
Details RINCO ULTRASONICS AG's warranty obligations and user requirements.
Provides technical specifications for the HW35-3 hand held device.
Details technical specifications for the RL35 ultrasonic generator.
Procedure for checking the device upon receipt and identifying shipping damage.
Responsibilities and procedures for handling damage incurred during transit.
Recommendations for optimal device placement and environmental conditions.
Description of the controls and indicators for the HW35-3 hand held device.
Description of the controls and indicators for the RL35 ultrasonic generator.
Criteria for selecting a suitable operating location for the device.
Steps for preparing and connecting the ultrasonic welding system.
Detailed description of the converter, its function, and handling precautions.
Information on the horn, its function, tuning, and material properties.
Instructions for safely replacing the horn on the ultrasonic welding tool.
Explanation of the program selector switch functions and internal placement.
Guidelines for performing general maintenance and safety precautions.
Information on the maintenance requirements for the hand held welding device.
Details regarding the maintenance requirements for the generator unit.
Safety precautions and handling guidelines for the vibration system and converter.
Instructions for cleaning and maintaining the threaded coupling between converter and horn.
Troubleshooting guide for errors encountered during device startup.
Troubleshooting guide for errors encountered while the generator is operating.
Wiring diagram for the device housing, including automatic start configuration.
Information on the location of fuses within the RL35 generator.
Table detailing fuse types and ratings for different generator configurations.
Diagram of the RL 35 generator rear panel showing connection sockets.
Table listing device sockets, connection plugs, and their order numbers.
Table showing amplitude values for different generator and horn configurations.
Graphical representation of amplitudes for 35 kHz RL generators with amplified converters.
Technical drawing and details on the stud length of vibration components at 35 kHz.
