2
1. Install your Floodlight.
Center the mounting
plate over the bracket
and secure it with a
screw.
Be sure to pull the wires through
the hole in the mounting plate
before screwing it in.
With power turned
o at the breaker,
screw the mounting
bracket into your
electrical box.
WARNING: Risk of
electrical shock.
Disconnect power
at the fuse or
circuit breaker
before installing.
Verify that the supply voltage
is correct. Connect fixture to
a 100 VAC~240 VAC 50/60 Hz
power source.
Properly ground fixture.
Always follow code standards.
If you are outside of North
America, installation and
wiring must be performed by a
licensed electrician.
CAUTION: Risk of fire. Do not
install near combustible or
flammable surfaces.
NOTICE: Floodlight must
be installed on a UL listed
weatherproof electrical box.
32
To Next Page
Loading...
Need help?
General
