ring Power Pack User Manual

Installation instructions
1. Plug the power adapter from your Ring Alarm Pro into the Power Pack's
orange Power In port.
2. Wait a few seconds for the Power Pack LED light to turn green.
Solid green means it's charging. When it's fully charged, the LED turns off.
3. Connect the Power Pack to your Alarm Pro using the short
1
double-sided
USB-C cable. Match the blue and orange connector ends to the correct
Power In (orange) and Power Out (blue) ports. The Power Pack will finish
charging while it's connected to your Alarm Pro.
You can check on the Power Pack battery status using the Ring app.
Tap on the Alarm Pro Base Station device page, then tap on the
Battery Health tile to see all connected Power Packs.
Powers eero wifi 6 Extenders
You can use these same steps to add a Ring Power
Pack to an eero wifi 6 Extender (sold separately).
3

ring Power Pack Specifications

General

Battery type	Lithium-ion
Capacity	6, 000 mAh
Weather Resistance	Weather resistant
Input	5V DC, 2.0A
Compatibility	Ring Video Doorbell 2