To Next PageTo Next Page
Need help?Do you have a question about the ring RESC512 and is the answer not in the manual?
General| Brand | ring |
|---|---|
| Model | RESC512 |
| Category | Battery Charger |
| Language | English |
Connect battery leads only when the mains supply is disconnected to prevent explosion risk.
Ensure adequate ventilation and prevent flames/sparks due to explosive gases escaping during charging.
For indoor use only, except for specific Maintenance SmartCharger and SmartCharge4 models.
Disconnect the supply before making or breaking battery connections to prevent shock hazards.
Charger automatically adjusts rate, stops when fully charged, and maintains connection indefinitely.
Charger casing provides protection against dust and low-pressure water jets.
Visual display of the current stage in the charging cycle.
Confirms correct polarity connection.
Displays battery status remotely without mains power.
Steps for connecting the charger to a battery installed inside a vehicle.
Steps for connecting the charger to a battery outside of a vehicle.
Specific connection steps for batteries with a negative ground.
Ensure safe connection and plug charger into AC supply.
Breaks down lead sulphate crystals using pulse charges to restore battery health.
The main charging phase, applying 80% of the required charge.
Tops up battery to full capacity with declining current for optimal power absorption.
Maintains 100% charge indefinitely without overcharging, ideal for intermittent use.
Lists part numbers, voltage, rates, and recommended battery sizes.
