To Next PageTo Next Page
Need help?Do you have a question about the ring RSC516 and is the answer not in the manual?
General| Reverse Polarity Protection | Yes |
|---|---|
| Short Circuit Protection | Yes |
| Thermal Overload Protection | Yes |
| Charging Ports | 1 |
| Battery Types | Lead Acid |
| Charging Stages | 8 |
Only connect battery leads when mains supply is disconnected. Prevent flames, sparks, and ensure ventilation.
Applies to most models, excluding Maintenance SmartChargers and SmartCharge4.
Always disconnect the power supply before altering battery connections.
Suitable for single batteries, lead acid, Gel, AGM, or calcium with 6 cells.
The supply cord is not replaceable. Damaged cords mean the charger should be scrapped.
Not for use by children or persons with reduced physical, sensory, or medical capabilities.
The casing offers protection against dust and water ingress.
Steps for connecting the charger to a battery inside a vehicle.
Procedure for connecting to a negative ground battery.
Steps for connecting the charger to a battery outside a vehicle.
Ensure the SmartCharge is connected safely and correctly to the battery.
Connect the SmartCharge AC power lead to the AC power supply.
For RSC501/RESC501, select correct voltage (6V or 12V) using the switch.
Remove AC plug, then red (+) clip, followed by black (-) clip.
Details the stages for Maintenance, SmartCharge4 (3-stage) and SmartCharge8/12/16 (7-stage).
Pulse charging to break down lead sulphate crystals.
Shows available charge rates and maximum recommended battery sizes for each part number.
Details input voltage, charging voltage/current, battery types, capacity, dimensions, weight, and protection.
