ELECTRIC SCOOTER / ENG
13
ADJUSTING THE DISC BRAKE, HANDLEBAR, TIRES
If the brake is too tight, use the M5 hexagon wrench to loosen the screws on the caliper, and slightly send
back the brake cable to shorten the exposed length, then tighten the screws. If the brake is too loose,
loosen the screws, and slightly pull out the brake cable to lengthen the exposed length, then tighten the
screws.
If the handlebar and its stem sway during riding, use the hexagon wrench to tighten the screws on the
folding mechanism.
If your tires are flat, remove the screw-on cap from the valve, and connect the extended nozzle adapter to
the valve for pumping up
To Next Page
Loading...