ring RX1 - Assembly and Setup; Charge Your Scooter

ELECTRIC SCOOTER / ENG
3
ASSEMBLY AND SET UP
1. Assemble the scooter and put it on
the kickstand, then lock the assembly mechanism
using the moving ring
2. Attach the handlebar to the stem
using Allen screws
3. Tighten the screws onto both sides of
the stem with the Allen wrench
4. After the assembly, press the power
button to check if it is working properly
CHARGE YOUR SCOOTER
Charge the battery for the first time 6-8 hours as the first charge. After that, charge it until red
charger light turns green (approx. 4-5h)
Lift up the rubber
flap on the side
under the tread
Plug the power
adapter into the
charging port
When charging is
completed, put back
the rubber flap