What about that Reset button?
You probably won’t need it, but if your Transformer
is plugged in and the light around the button on the
front is not illuminated, you may need to press it.
Open the Transformer door
and check to see if the Reset
button popped up. If so, press
it to reset your Transformer.
If it pops up again, double-
check the total wattage of
your fixtures. Make sure it’s
below 200W totoal wattage
(refer to page 11).
Conceal the cable.
Now that setup is complete, you can hide the low
voltage cable (if updating an existing system, you’ve
probably already done that - ignore this part).
To bury the cable, dig a narrow, shallow trench
(up to 6” deep) along the wiring route. Lay the
cable inside the trench and cover it over with the
displaced ground.
Or, if your cable runs through an area with soil (like a
flower bed) you can cover it with a layer of mulch.
1918
To Next Page
Loading...