Rinnai New Zealand 3 Operation Manual:01-07
DELUXE WATER CONTROLLERS
To return to normal mode press the 'Mode' button once,if no buttons are pressed for a period of
approximately 10 seconds the controller will return to normal mode.
The time is always displayed regardless of whether the Water Controller is turned
ON or OFF.
The clock may need reseting if power to the water heater unit is disrupted due to
a power failure or if the power is switched off over a prolonged period.
Setting The Sound Options
To set the sound options press the 'Mode' button once to place the controller into ‘Voice’ mode.
Use the or buttons to select the desired audible setting as follows:
Voice High, Med, Low or Off, sets the voice prompt volume but does not affect the audible tones.
Sound Off, mutes all voice prompts and audible tones.
To return to normal mode press the 'Mode' button once, if no buttons are pressed for a period of
approximately 10 seconds the controller will return to normal mode.
Voice prompts only available when Deluxe Bathroom water controller(s) are
installed.
Adjusting Temperature
Simply press the 'hot water temp' or buttons until the
required temperature is displayed on the Digital Monitor.
To operate the water heater, open any hot water tap. This will
automatically light the burner, providing hot water. The ‘In Use’
indicator will illuminate on the Water Controller.
Once the hot water is running, if the set temperature is either too hot or cold press the or
buttons until the desired temperature is reached.
Whilst hot water outlets are open the set temperature may be lowered. However
they cannot then be raised above 43°C. In addition transfer of 'priority' between
controllers is not possible. These are safety features.
CHECK WATER TEMPERATURE BEFORE USE.
A parent or carer should always check the temperature before a child is placed
in contact with hot water.
NOTE
NOTE
HOTHOT
COLDCOLD
ON!ON!
NOTE
CAUTION
To Next Page
Loading...
Need help?
General
