To Next PageTo Next PageWhat to do if the Rinnai Dryer has a flame failure?
If your Rinnai Dryer experiences flame failure, first, ensure the gas supply is fully turned on. Next, inspect and clean the lint filter, back filter, and air inlet filter. If the issue persists after these steps, arrange for a service.
What to do if my Rinnai Dryer has an ignition failure?
If your Rinnai Dryer fails to ignite, verify that the gas supply is turned 'on'. Then, turn the appliance 'off' and then 'on' again. If the problem continues, arrange for a service.
How to fix filter blockages in a Rinnai Dryer?
To address filter blockages in your Rinnai Dryer, check and clean the lint filter, back filter, and air inlet filter.
Why has the 'time remaining' not changed on my Rinnai RD-400AU Dryer?
If the 'time remaining' display on your Rinnai Dryer hasn't changed for several minutes, especially in Automatic mode, it's because the control system is continuously recalculating the drying time based on the garment's drying rate. This is normal.
Why is there a delay after pressing the start/pause button on my Rinnai RD-400AU?
A delay after pressing the 'Start/Pause' switch before the Operating indicator shows red is a normal operation for the Rinnai Dryer. However, if the burner doesn't ignite at all, contact Rinnai.
What causes clicking noises in my Rinnai RD-400AU Dryer?
The clicking noises you hear in your Rinnai Dryer after starting or finishing a cycle are due to the expansion and contraction of burner components with heat. This is a normal operational characteristic.
Why is steam coming from my Rinnai RD-400AU discharge duct?
Steam emitted from the discharge duct terminal of your Rinnai Dryer is normal.
What to do if Rinnai RD-400AU drum keeps turning after finishing tone?
If the drum of your Rinnai Dryer continues to turn after the finishing tone, opening the dryer door will cancel the 'Extra Soft' programme.
General| Type | Vented |
|---|---|
| Capacity | 4 kg |
| Height | 670 mm |
| Energy Rating | 2 Stars |
| Heat Pump Technology | No |
Step-by-step guide on how to use the dryer in automatic mode.
Step-by-step guide on how to use the dryer in timer mode.
Instructions on how to clean the lint filter after each drying cycle for efficiency.
Instructions on cleaning the back filter located inside the drum.
Lists and explains the various safety features integrated into the dryer.
A list of checks to perform before calling for service.
Details the power requirements and connection methods for the appliance.
Covers installation requirements and clearances for the exhaust duct system.
