IMPORTANT! The locking levers must be fully closed and secure before the Firefly
TM
2.5 can be safely
used. A curved green line appears on the inner surface of the coupler plate when it is fully closed and
locked onto the pins. Do not use the Firefly
TM
2.5 if you cannot see this curved green line.
To remove the Firefly
TM
2.5 from wheelchair
To remove the Firefly from the wheelchair, following the same procedure as attaching it to the
wheelchair but in reverse. First lock the steering by twisting the headset clockwise until the line on the
bottom of the headset turns red. Apply the wheelchair's wheel locks. Push the middle of the handlebar
forward with one hand, then pull one of the coupler plate's locking lever rearwards to the unlocked
position. Next push the middle of the handlebar forward with the opposite hand, maintaining enough
force to keep the caster wheels lifted off the ground, then pull the other coupler plate's locking lever
rearward to the unlocked position. Now gently lower the caster wheels to the ground by slowly reducing
pressure on the handlebar.
To Next Page
Loading...
