Rio 600 - Page 18

Page 12
Setting up your Rio
If the installation menu does not display automatically, follow these
steps to begin the installation manually:
1
Click on the Start button in the bottom left corner of the
computer screen, then select Run...
2
Type d:\setup32.exe in the field marked Open. If your computer’s
CD-ROM drive uses a letter other than “d”, substitute that letter
for “d”.
3
Click on the OK button and follow the on-screen instructions.
Mac
1
Place the Rio software CD in your computer’s CD-ROM drive.
2
The CD contents are displayed automatically. To manually display
the CD contents, double-click on the icon on your computer’s
desktop.
3
Double-click on the Install icon. The installation menu is displayed.
4
Click on the Install button.
5
Reboot your computer when installation is complete or you are
prompted to do so.