02
Ripple Maker II
Set-Up
Where to place the Ripple Maker II in your facility
Connecting your Ripple Maker II to power
Connecting to the internet
Preparing for your first print
This section includes information about:
WATCH THE
UNBOXING VIDEO
2.1 Placement in Your Facility
Place the Ripple Maker II in accordance with the
safety instructions.
Install close to an electrical outlet.
Ensure the Ripple Maker II is on a level surface.
Position the Ripple Maker II in a convenient location
for the bartender / barista, keeping in mind the work
flow of the bartender / barista and other users.
Make sure the Ripple Maker II is placed next to an
Ethernet outlet or where there is good Wi-Fi signal.
When searching for a suitable location for the Ripple
Maker II in your facility, use the following guidelines:
-3- -4-
To Next Page