off. Now the run LED color is set successfully.
Attaching To Rod
This alarm is designed to be attached directly to your rod.
Drop-back Function
When a drop-back bite occurs, the relevant LED will twinkle, and the
alarm will emit a continuous low sound. The LED color will remain white
for around ten seconds after the alarm stops sounding.
Memory Function
All settings you have made on last use will automatically be saved and
apply to next use, regardless of whether you switch the device off or
not.
Turning Off the Alarm
To turn off the alarm, press and hold the Power button located on the
left side (refer to the picture above) for one second. You will see both
LEDs flash once, and hear one low beep. This indicates that the alarm
is turned off.
Charging
Before charging, turn off the alarm. Attach the magnetic charging cable
to the charging port located on the lower back of the alarm. You will
hear two short beeps, and the multi-color run LED will come on and
then its brightness will periodically dim and brighten. Once the alarm is
fully charged, the run LED will turn green.
Kind Reminder:
Only the paired transmitter can activate and receive responses from each receiver.
To Next Page
Loading...