RITE-HITE Revolution HVLS Fan User Manual

12 Publication: AMEN00064 2019‑03‑07
Revolution
®
HVLS Fan • Rogue
®
HVLS Fan Installation/Service/Owner's Manual Rite‑Hite
®
INSTALLATION
Step 8 – Fan Electrical Installation (TYPICAL)
Fan Control Box
(14in x 16in x 8in
VFD Enclosure)
Line Voltage
Line Voltage
Fan Motor
Disconnect
Incoming Power from
End User Supplied
Branch Circuit
Protective Device
Motor Voltage
160ft [50m] Max Motor Run
Fan Motor
3ɸ
B
A
A. Mount Fan Control Box (VFD Enclosure) at maintenance accessible height.
B. Mount disconnect at accessible height, according to local code.
Mount Fan Control Box (A) and disconnect (B) safely outside the fan diameter.
Field Wiring
Power/High Voltage
Incoming Power
Terminated at
F1, F2, F3
Fuse Holder.
Incoming Power from
End User Supplied
Branch Circuit
Fan Motor
Disconnect
Fan Control Box
To Fan Motor
Terminal Torque 20lb‑in Max
ACCEPTABLE:
Unshielded Stranded Conductor Types:
THHN/THWN in Metallic Conduit
Shielded Stranded Cable Types:
Belden 29501
AlphaWire V16014
Use copper wire only, minimum 600V 75°C
NOTE:
‑ If fan runs backwards
swap 2 motor wires.
- L3 not used on 1ɸ fans.
Copper conductors only
14‑8 AWG, 75°C min.
Control/Low Voltage
Radio PCB
Jumper Wire
DO NOT Remove
Optional
Temperature
Sensor
Enable Jumper:
Opening the factory installed jumper between
S1 and SC will cause the fan to initiate a
controlled stop. These points may be wired to
a contact from a re system or BMS to stop the
fans during an alarm or water ow event.
OUT
Patch cord
Blue White Yellow Brown Red Grey Orange
Black
Figure 9
Figure 10

RITE-HITE Revolution HVLS Fan Specifications

General

Brand	RITE-HITE
Model	Revolution HVLS Fan
Category	Fan
Language	English