Publication: AMEN00064 2019‑03‑07 3
Rite‑Hite
®
Installation/Service/Owner’s Manual Revolution
®
HVLS Fan • Rogue
®
HVLS Fan
SAFETY
Lockout Procedure
Barricade work area and post safety warnings.
Power supply/control must:
• Be disconnected or locked in OFF
position using a lockout device approved
by local codes.
• Have signage that:
− Clearly states repairs are being made.
− Identies person responsible for lockout condition.
NOTE: Only this person should be able to remove
warnings and lockout device.
− Withstands environmental conditions (weather, wet,
and damp, etc.) and remains readable.
General
DANGER
Installation to be completed in accordance with the
National Electric Code, ANSI/NFPA 70‑1999, and
local codes.
L'installation doit être eectuée conformément au
Code national de l'électricité, à la norme ANSI/NFPA
70‑1999, et aux codes locaux.
DANGER
A qualied electrician should install the wiring in
accordance with local electrical codes.
Use lockout procedures to prevent death or severe
personal injury.
L'installation du câblage doit être eectuée par un
électricien qualié, conformément aux normes
électriques nationales et locales.
An de réduire le risque de blessures graves ou
mortelles, utilisez des procédures de verrouillage.
!
CAUTION / ATTENTION
Barricade the work area until the unit(s) have
been completely installed.
Barricader la zone de travail jusqu'à ce que
l'unité(s) ont été complètement installé.
!
WARNING / AVERTISSEMENT
Rotating fan blades can cause serious injury.
Les lames rotatif du ventilateur peut causer des
blessures graves.