To Next PageTo Next Page
Need help?Do you have a question about the Rittal SK 3329. series and is the answer not in the manual?
General| Brand | Rittal |
|---|---|
| Model | SK 3329. series |
| Category | Air Conditioner |
| Language | English |
Information about the different sets of assembly instructions provided.
Details on the declaration of conformity document.
Importance of keeping instructions with the product.
Explanation of symbols for instructions, danger, caution, and notes.
Explanation of how the cooling units dissipate heat.
Details the compression refrigeration system and its components.
Describes the controller types (Basic/Comfort) for setting functions.
Explains connecting multiple cooling units via serial interface.
Details safety features like pressure-operated switch and thermal winding shields.
Explains condensation formation and automatic evaporation.
Information on filter mats, their function, and monitoring.
How the door limit switch functions to control the unit.
Details the additional interface for higher-level monitoring systems.
Criteria for selecting a suitable location for the enclosure.
General guidelines for assembling the cooling unit.
Guidance on arranging components for optimal airflow and climate control.
Options for fitting the unit (external, partial, full internal).
Steps for cutting openings in the enclosure for mounting.
Instructions for attaching the unit externally to the enclosure.
Steps for mounting the unit partially inside the enclosure.
Detailed steps for fully mounting the unit inside the enclosure.
How to connect the condensate drain hose.
Important electrical installation guidelines and regulations.
Specifies voltage, frequency, and connection requirements.
Information on protecting against overvoltage and supply line capacity.
Specific electrical connection notes for three-phase units.
Details on connecting and using the door limit switch.
Compliance with flicker standards and potential solutions.
Recommendations for potential equalisation connection.
General instructions for performing electrical installation.
How to connect multiple units using a bus connection.
Using the serial interface card for monitoring and integration.
Steps for installing the power supply and connecting system messages.
Final steps before operation, including filter installation.
Instructions for installing filter mats.
Steps for fitting the display and grille for internal mounting.
How to set up the filter mat monitoring function.
Operating the unit with the Basic controller.
Details voltage variants and features of the Basic controller.
Explanation of LED indicators for status and errors on the Basic controller.
How to activate and use the test mode for the Basic controller.
Procedure for setting the desired temperature.
How to reset the Basic controller after an alarm.
Operating the unit with the Comfort controller.
Details voltage variants, features, and master-slave function.
How to activate and use the test mode for the Comfort controller.
Information on navigating and changing parameters.
Lists and describes parameters that can be adjusted.
Visual guide to the programming sequence and parameter adjustments.
How system messages are displayed and evaluated via relays.
Configuration of master-slave connection for multiple units.
Interpreting system messages and required resets.
Detailed troubleshooting guide for Comfort controller system messages.
How to reset the Comfort controller after specific faults.
Overview of the cooling unit's maintenance-free design and general care.
Instructions for cleaning unit components using compressed air.
Specifies cutout and hole dimensions for external installation.
Specifies cutout and hole dimensions for partial internal mounting.
Specifies cutout and hole dimensions for full internal mounting.
