2
2.4. Safety Plates
The warning plates shown in Table 4 are present on the partly-completed machine.
It indicates the prohibition to remove the devices and the safety
protections installed; it
is typically also accompanied by an explanatory text: DO NOT
REMOVE THE PROTECTIVE DEVICES.
It indicates the prohibition to perform any intervention (including lubrication and
cleaning)
close to moving parts; typically, it is also accompanied by an explanatory
text:
DO NOT REPAIR OR ADJUST WITH PARTS IN MOTION.
It signals the danger, due to the presence of mobile parts close to the zone ofthe partly
completed machine where it is located.
It reports the danger of electrical voltage.
It reports the danger of hot surfaces.
It reports the obligation to read the assembly manual/instructions.
Indicates it is forbidden to touch the zone where it is positioned
Pressurised nitrogen.
Remove the voltage from the disconnector before carrying out maintenance on the
machine. Remove power to the entire system before carrying out operations inside the
It is forbidden to connect other devices to the control transformer.
Obligation to convey the discharge of the safety valves.
Table 4 - Description of the warning labels on the machine.
To Next Page
Loading...
