2
4.3.1.
Lifting
DANGER: the lifting operations must be performed under the direct supervision of a qualified mechanical
maintenance operator.
ATTENTION: during all these operations, exercise the necessary caution to avoid collisions and tipping
over, handling the partly-completed machine in a manner that maintains conditions of balance.
DANGER: Make sure there are no unauthorised personnel near the area where the lifting, handling, and
unloading operations are taking place. Such persons must always remain at a safety distance.
Lifting for handling and subsequent positioning of the machine must be performed using straps that must be
inserted into the appropriate lifting pockets of the structure, as shown in the figure.
Follow the previous recommendations for correct handling operations.
x
never use two lifting means simultaneously;
x
never stand beneath the suspended loads;
x
if steel ropes are used, fit always the loop on the end on the lifting hook;
x
if steel ropes are used, pay attention not to create narrow bends, i.e. with a bending radius lower than
the loops on the end of the rope;
x
use ropes of suitable length so that the angle between ropes and the horizon is always greater than
45°.
To Next Page
Loading...
