9
. MAINTENANCE CLEANING AND STORAGE AT THE END OF
THE CYCLE
Cleaning should only be undertaken with the power off and when the appliance is cold.
Do not immerse electrical components in water to clean them.
Dirt can cause damage to the appliance, to the incubation and to the people using it. Make sure both the
inside and outside of the incubator are clean.
At the end of the cycle, thoroughly clean the lower part of the incubator with neutral detergent first, then
disinfect it with a chlorine-based disinfectant or some household bleach. Do not use alcohol or other chemical
detergents.
Thoroughly clean the lid exterior with a soft cloth, dampened with clean water and squeezed out.
The external part of the protection grill of the lid should be cleaned with a soft cloth moistened with a chlorine-
based disinfectant or some household bleach. Blow the internal part with compressed air to remove any
feathers dropped by the chicks.
During these operations the incubator and the egg turning unit must be unplugged.
Do not use solvents, diluents and toxic chemicals. Please refer to the chart at the end of this manual for the
list of the substances that would damage the plastic parts.
Allow all parts to dry thoroughly. Place the incubator in a dry place, safe from hits and changes in temperature.
Do not put any other object on top of it.
Do not attempt maintenance on electrical components.
10. REMOVAL OF THE EGG TURNING UNIT
If you need to remove the egg turning unit, follow the instructions below:
a) Remove the egg tray (photo O).
b) After having turn upside down the base of the incubator, remove the two screws at the bottom (photo R
and S).
c) Remove the screw inside the base of the incubator (photo T).
d) Remove the egg turning unit.
WARNING!
DO NOT OPEN THE EGG TURNING UNIT BY REMOVING THE FOUR SCREWS SHOWN
BY THE ARROWS (PHOTO U). OPENING THE UNIT WILL CAUSE ITS GUARANTEE TO
BE NULL AND VOID.
11. WARRANTY
The warranty is valid only if the incubator is used for its intended use.
Apart from the ordinary and extraordinary maintenance described in the CLEANING section, to be carried out
as described, any repair or modification made to the appliance by the user or by unauthorized companies will
cause the warranty to be null and void.
The warranty does not cover any damage caused by incompetence or negligence in the use of the incubator,
or by bad maintenance, or lack of it.
The products we sell are covered by warranty at the following conditions:
1. The warranty is valid for a period of twelve/twenty four (12/24) months: 12 months for firms, 24 months for
private individuals.
2. The producer undertakes to replace at its discretion the malfunctioning or wrongly manufactured parts,
only after having thoroughly checked them and having verified the fault.
3. Transport and/or shipment costs are always at the purchaser’s care.
4. During the period of warranty, all replaced products become the producer’s property.
5.
Only the original buyer who fulfills the normal maintenance operations described in this manual can benefit
from this warranty. Our responsibility on the warranty expires when the original owner cedes the property of
the product or if it has been modified
.
6. The warranty does not cover damages caused by excessive stress, such as in case the product is used
after having ascertained an anomaly or overheating of the motor, in case of improper use, and if the use
and maintenance instructions are not observed.
7. The producer is not to be held responsible for any difficulty that may arise in the reselling or in the use in
foreign countries, caused by regulations existing in the Country where the product was sold.
8. The faulty product or part of the product must be delivered to the producer for its replacement; if not, the
replaced part will be charged to the buyer.
- 21 -
Copyright © 2018 River Systems - All rights reserved
EN
To Next Page
Loading...
